DARTH VADER - EP. V
Darth Vader comes with an extra head model!
Choose between “standard gray” or “translucent red” resin for Darth Vader’s lightsaber!
ALL BUSTS ARE:
Printed in gray ABS like resin for stronger prints.
Hollowed at 2mm thickness.
Oriented and drain holes properly placed to prevent suction lines.
Supported properly to prevent any damage to model when supports are removed.
Printed in fewest parts possible.
Washed in 99% IPA, followed by a wash with an ultrasonic cleaner for crisp, clean prints.
Cured inside and out with UV curing machines.
Dry fitted to ensure all parts assemble with ease.
Unassembled and thoroughly packaged to prevent damage during shipping.
Darth Vader comes with an extra head model!
Choose between “standard gray” or “translucent red” resin for Darth Vader’s lightsaber!
ALL BUSTS ARE:
Printed in gray ABS like resin for stronger prints.
Hollowed at 2mm thickness.
Oriented and drain holes properly placed to prevent suction lines.
Supported properly to prevent any damage to model when supports are removed.
Printed in fewest parts possible.
Washed in 99% IPA, followed by a wash with an ultrasonic cleaner for crisp, clean prints.
Cured inside and out with UV curing machines.
Dry fitted to ensure all parts assemble with ease.
Unassembled and thoroughly packaged to prevent damage during shipping.
Darth Vader comes with an extra head model!
Choose between “standard gray” or “translucent red” resin for Darth Vader’s lightsaber!
ALL BUSTS ARE:
Printed in gray ABS like resin for stronger prints.
Hollowed at 2mm thickness.
Oriented and drain holes properly placed to prevent suction lines.
Supported properly to prevent any damage to model when supports are removed.
Printed in fewest parts possible.
Washed in 99% IPA, followed by a wash with an ultrasonic cleaner for crisp, clean prints.
Cured inside and out with UV curing machines.
Dry fitted to ensure all parts assemble with ease.
Unassembled and thoroughly packaged to prevent damage during shipping.
PLEASE NOTE - Uncured resin is toxic! Even when properly and thoroughly cleaned, pockets of resin may still be trapped inside the model and may leak out during shipping. If this is the case, STOP WHAT YOU’RE DOING and wash your hands with soap and warm water. Clean the model and any contaminated area with IPA (rubbing alcohol.) Once cleaned, place the model outside in direct sun light to allow any left over resin to fully cure. Make sure to not leave the model in direct sunlight for too long. This could cause the print to become brittle and easily break.